3/27/2023 0 Comments Pcsx not recognizing controller![]() ![]() Yes I am sure I am using that LilyPad dll, version is 0.11.0 (r5112). the issue appears also when mapping buttons with the PS3 controller in the controller settings. PCSX2 version: 1.5.0.r2120.07c69ebed-1 OnePAD 2.0.0 plugin on Linux Description of the issue: When attempting to use a DualShock 4 over USB on Linux (hooked directly into the system), the plugin gi. I ticked 'DirectInput' and now I have other devices showing up, one of them being DX MiJ Virtual Game Controller which, when Testing, seems to respond to all of my PS3 buttons. Also are you sure you're using the 'LilyPad-MotioninJoy.dll' which should be stored in the plugins folder? This is needed for the specific profile you're using - 'Playstation 2' ( for PCSX2 with pressure sensitive)'. (08-12-2012, 07:03 PM)BigLoz Wrote: Tick 'DirectInput' in the 'General' tab on the LilyPad settings. I decided to showcase how to fix a small thing that's considered a issue while using the Playstation 2 Emulator known as (PCSX2) It's when your Xbox 360 Controller Doesn't Respond when you. ![]() As I mentioned before, using SSSPSX plugin it responds well. I closed both windows and went to school, when I came back to my laptop, I can still run games but the controller won't work. I'm certain someone may have asked this before, but I downloaded PCSX2 1.4 and then got DS4 to Input Mapper with Scp Virtual Bus Driver and I connected my ps4 controller and it was working fine. How do I disable Pad 2? Also currently I only have this cable to work with, but I do not see any physical problems with it. Just got PCSX2 and the controller is not working. Testing that one my PS3 controller does seem to respond. One thing I noticed was that you had DX MiJ Virtual Game Controller under Device Diagnostic. Have you checked the condition of the cable you're using/tried another cable out? I got a lot of errors because of a weak USB cable at the start. I'd also recommend that you disable Pad 2 if you never intend to use it since I see it has been configured. It needs to be detected before the emulator can use it. The configuration window should appear normally and your controller should be detected and ready for configuration.(08-12-2012, 07:20 PM)Ravin1337 Wrote: Check my editted post. If you have an issue with a controller, first make sure you can see it under Device Diagnostics.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |